ADVERTISEMENT

WASHINGTON – The Federal Aviation Administration said Monday it is proposing a $12 million civil fine against Southwest Airlines for failing to comply with safety regulations related to repairs on Boeing 737 jetliners.

Beginning in 2006, Southwest made “extreme makeover” alterations to eliminate potential cracking of the aluminum skin on 44 jetliners, the FAA said. An FAA investigation determined that Southwest’s contractor, Aviation Technical Services Inc. of Everett, Wash., failed to follow proper procedures for replacing the fuselage as well as other work on the planes, the agency said.

All of the work was done under the supervision of Southwest, which was responsible for seeing that it was done properly, the FAA said.

Southwest then returned the planes to service in 2009 and began flying them even after the FAA “put the airline on notice that these aircraft were not in compliance” with safety regulations, the agency said.

During its investigation, the FAA also found that Aviation Technical Services’ workers applied sealant beneath the new skin panels but did not install fasteners in all of the rivet holes fast enough for the sealant to be effective.

“This could have resulted in gaps between the skin and the surface to which it was being mounted. Such gaps could allow moisture to penetrate the skin and lead to corrosion,” FAA said.

The contractor also failed to follow requirements to properly place the planes on jacks and shore them up while the work was being performed, the FAA said.